This article is about wrapping your headphones. Most people use headphones and after using they throw them away. By doing this, the internal wiring of the headphones may get damaged. Sometimes, you are in a hurry and need to go outside so you just tangled your headphones to be quick to wrap them.
Let me tell you this is not the correct way to wrap headphones. If you do not know the real way for wrapping your headphone then keep reading this guide till the end to get the answer to your query.
How To Wrap Your Headphones Properly?
How To Wrap Your Headphones Properly?
How To Wrap Your Headphones Properly?
It can be really exhausting to warp your headphones when you do not know how to wrap them. A few years ago there was no concept of this whole thing but now people want to know it. When you start wrapping the wires get tangled and make the whole procedure frustrating.
Here we have provided you with 3 simple ways that you can use to correctly wrap your headset.
- Doing Crazy 8 Knots
- Doing a Double Wrap
- Making a DIY Headphone Holder
1. Doing Crazy 8 Knots
1. Doing Crazy 8 Knots
1. Doing Crazy 8 Knots
To apply this method, you will need to make sure that your headphones are not in knots.
Step 1: Before you begin folding the headphones, grab your hand and place the earbuds under your palm.
Step 1:
Step 2: Wrap it with the index finger until you have a little cord left to tie the knot.
Step 2:
Step 3: Carefully remove it with your pointed fingers and wrap the restring fingers between the headphones to make a simple knot.
Step 3:
Note: The cords should go around each finger in the same direction. It will be a figure 8, not a loop.
Note:
2. Doing a Double Wrapping
2. Doing a Double Wrapping
2. Doing a Double Wrapping
This method also needs to ensure that the headphones or earbuds are not tangled.
Step 1: Begin folding the headphones in the middle again. Keep doing this until you reach the size of a small ruler.
Step 1:
Step 2: Carefully fold one plug end of the headphone over the other and tie a knot.
Step 2:
Note: You will need to create a simple bow by wrapping the plug end a few more times around the center.
Note:
3. Making a DIY Headphone Holder
3. Making a DIY Headphone Holder
3. Making a DIY Headphone Holder
To make a DIY holder, you will need a small velcro strap and some glue.
Step 1: Put velcro straps on the back of the headphones.
Step 1:
Step 2: Velcro should be placed at the top of the plug (Hot glue works well for this).
Step 2:
Step 3: Wait 5-10 minutes for the glue to dry and stick well on the velcro headphones.
Step 3:
By doing this, your earbuds should be wrapped. You can fold the headset however you wish and wrap them with Velcro straps.
Conclusion
Conclusion
Conclusion
This was all about wrapping your headphones. Start with the headphones in one hand and the rest of the cables on the floor. Keep the cable 1.5 feet from the headset and start making a loop with your fingers until you’ve used the cable all the way through. Secure the cable with a Velcro strap.
We hope our guide helped you learn how to wrap headphones easily. Leave us a comment to let us know if you found this guide helpful.
Contents
Contents
Contents